 |
| Basic Method 1 Setup |
 |
| Here are three machines set together. The one on the left is using the sheath and rod. |
 |
| Here you can see the push rod and clevis attached to the crank. |
 |
| Two machines mounted vertically controlling a crossover. |
 |
| A bell crank used to change direction of the push rods |
 |
| Notice the one that used the bell crank is on its side. The push rod extends through a hole in a girder. |
 |
| Close up of the push rod thought the girder |
 |
| The final result the 1/8" tube sticking up and a piece of .039" Piano wire operating the turnout. |
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.